Sur-Ron LBX Pedal Conversion Kit

Regular price £99.95 Sale price £49.95 Save 50%
17 in stock

Summary

Official Sur-Ron kick pedal system conversion kit. Allows for independent power application from throttle or through pedals. Please note the kit is designed for machines with restricted power and speed ie 25kmph or 15 mph as a EAPC (Electrically assisted pedal cycle) and therefore has a very small rear sprocket to match. If you use the small rear sprocket in the kit and the bike is used in full power mode with large throttle openings at low speed then it can cause serious damage to the motor internals. So we recommend that if you want full power/speed with the pedal kit fitted then DO NOT fit the small rear sprocket supplied with the kit, but retain your original 48T standard sprocket,  You will require a longer drive chain when installing with non standard sprockets.      

Fitment

All models Light Bee 

Sur-Ron Pedal Kit Installation Video Please use the following link, please note its important to carry out some pre greasing and adjustment on the pedal kit to ensure optimum performance. Details are sent with the kit   

https://www.youtube.com/watch?v=FVl66T8No_M

Important Notice: Pedal Kit

 Official Surron kick pedal system conversion kit.

This allows for independent power application from throttle or through pedals. Please note the kit is designed for machines with restricted power and speed ie 25kmph or 15 mph as a EAPC (Electrically assisted pedal cycle) and therefore has a very small 25T rear sprocket to suit. If you use the 25T rear sprocket in the kit and the bike is ridden in full power mode with large throttle openings at low speed then it can cause serious damage to the motor internals. So we recommend that if you want full power/speed with the pedal kit fitted then DO NOT fit the small rear sprocket supplied with the kit, but retain your original 48T standard sprocket. A longer length chain will be required for non-standard pedal kit sprocket.       

Pre Installation Notes:

To ensure the optimal performance from your pedal kit the application of extra grease to the bearings and pre adjustment is essential as follows: 

Remove Right Hand Nut

Loosen sprocket and remove

Remove locking nut and bearing cap

Slide crank shaft out, re grease with a quality grease

Re-assemble shaft and bearing cap

Tighten bearing cap until it starts to resist, then loosen a fraction for free movement so it turns smoothly

Replace lock nut (with thread locking compound recommended)

Replace Sprocket – leave loose for adjustment once fitted to the bike  

 

During use if you experience any extra free play on the pedal kit, stop use immediately and adjust, otherwise, bearings will become loose and lead to failure. Bearing failure by lack of maintenance and adjustment is not covered under warranty.  


Included

  • 1 x Complete Crank
  • 2 x Sprockets
  • 2 x Crank Arms
  • 2 x Pedals
  • 1 x Drive Chain

 

Please note a special tool is required to remove the swing arm nut if you do not have access to this tool, it can be purchased from the store by searching for 

SUR-RON AXLE REMOVAL TOOL